- Messages
- 2,218
- Reaction score
- 1,193
- Trophy Points
- 138
Hopefully someone smarter than me can help.
I suddenly cannot use Tranzcode via the Tranzcode GUI. Whenever I set it to run, the command prompt appears only momentarily before disappearing, and no files have been created.
I'm also noticing that if I try to run anything else directly, for instance "ipconfig" the command prompt runs it very quickly then instantly disappears. This issue was not happening until recently.
I suddenly cannot use Tranzcode via the Tranzcode GUI. Whenever I set it to run, the command prompt appears only momentarily before disappearing, and no files have been created.
I'm also noticing that if I try to run anything else directly, for instance "ipconfig" the command prompt runs it very quickly then instantly disappears. This issue was not happening until recently.